Wachsmuth-krogmann PCSD180T Bedienungsanleitung

CIRCULAR SAW INSTRUCTION MANUAL Item#3729 MODEL NO: PCSD180T PLEASE READ THESE INSTRUCTIONS CAREFULLY TO ENSURE THE S

before installing or removing blade. 1. To remove the blade (Fig.8, press the shaft lock so that the blade cannot revolve and use the hex wrench to lo

ridge.  To avoid a tearing out of the cutting edges when working sensitive area (if the surface is very smooth crepe tape also enables easy drawing

Both brushes should be replaced at the same time. Use only identical carbon brushes. Use a screwdriver to remove the brush holder caps. Take out the w

FUNCTIONAL DESCRIPTION Figure-1 1 FUNCTIONAL DESCRIPTION Figure 2 CL

FUNCTIONAL DESCRIPTION Figure-4 Figure-5 3 LIST OF MAIN PARTS 1) Battery pack 6) Nut 2) Upper guar

2345 Figure-7 Figure-8 GENERAL SAFETY RULES WARNING! Read and understand all i

situations. 6. Use safety equipment. Always wear eye protection. Dust mask, non-skid safety shoes, hard hat, or hearing protection must be used for a

guard is covering the blade before placing the saw down on bench or floor. Be aware of the time it takes for the blade to stop after switch is release

on a soft surface that might block the ventilation slots and result in excessive internal heat. Place the charger in a position away from any heat sou

use the correction screw. Adjusting the Cutting depth (See Fig.3&4) For the cleanest possible cut, set the cutting depth whenever possible 5 mm

2) Insert the battery pack into the charger, as shown in Fig 7, making sure the pack is fully seated in the charger. The red light indicator will il